OliNo

Renewable Energy

LLE T8-LedTL 22W 1200mm Nat White

Posted by Marcel van der Steen in Led lights Add comments

lle_t8_22w1200mm_60smd_eps_nwIn this short article I explain a measurement on the power factor. Measured is a led tube light from LedLightEurope. This is a 1200 mm long tube equipped with 60 smd leds. The power supply that is delivered as a separate block, is not in the tube and could be put inside the tube holder.

This article is available in measurement report: olino-pdf

Power Supply Unit

The used PSU is a black box. It can handle input voltages from 100 – 240 V and takes care of an output current of 540 mA, which is what the leds need.

lle_t8_22w1200mm_60smd_eps_nw_powersupply

The PSU used for the led tubelight, in not build in the tube but put externally

Power factor measurements

The power factor is measured during warm up of the tube.

lle_t8_22w1200mm_60smd_eps_nw_pf_warmup

PF, S and P during the warming up of the tube.

The consumed power P, as well as the apparent power S and the resulting power factor are all very stabl during the warmup period. See the scale values, the PF varies in between 0.96 and 0.97 which is due to rounding the values.

After that the lamp voltage is varied over the allowable range.

lle_t8_22w1200mm_60smd_eps_nw_pf_voltage

PF, S and P at different lamp voltages.

The PSU does its work well: little variations seen in all three parameters, when the lampvoltage is varied over the entire range of values from 100 – 250 V. The power factor remains high, between 0.95 and 0.99.

Current- and voltage form

The current and voltage are measured with a high sample frequency. The values are plotted in a graph, enabling to see their form. This form remains mainly the same for all tested lamp voltages.

lle_t8_22w1200mm_60smd_eps_nw_u_i_waveforms

Form of current and voltage when the led tube is fed with 226 V AC power.

The voltage form is a nice sine, and the current form is almost a sine. This current’s phase is also close to that of the voltage, resulting in a power factor close to 1.

lle_t8_22w1200mm_60smd_eps_nw_powerspectrumi_percent

Harmonic content of the current.

Little harmonic content, showing that the PSU is well adapted to the led tube.

Leave a Reply

 

WP Theme & Icons by N.Design Studio
Privacy Policy Entries RSS Comments RSS Log in